top of page

Nitrate Testing Important For Drought-Stressed Forages

6 hours ago
2 min read
 Don't hesitate to sample forages, and getting a representative sample is a
critical first step. Photo by Chabella Guzman
 Don't hesitate to sample forages, and getting a representative sample is a critical first step. Photo by Chabella Guzman

Nebraska Extension


Annual forages were planted on many acres this year under drought conditions. The

stressful conditions under which these forages were grown heighten the risk that

they could be high in nitrates. Accurately sampling and testing hay is the only way

to get a real understanding of the nutritive value of feed.


"Using values from previous years or a "book value" can be costly since a producer

may incorrectly develop a ration using values that aren't representative," said

Aaron Berger, Nebraska Extension livestock educator. "These forages should be tested

both for nitrates and quality, in order to plan for safe and cost-effective

feeding."


In addition to moisture, protein, and energy, annual forages harvested for hay, such

as foxtail millet, oats, sudan grass, and sorghum-sudan hybrids, should be analyzed

for nitrates. The only way to know if high levels of nitrate accumulation have

occurred is to test for it. See the UNL NebGuide "Nitrates in Livestock Feeding"

(PDF version, 319KB) for additional information.


When sampling hay, getting a representative sample is a critical first step. Samples

must accurately represent the entire lot of hay. The UNL NebGuide "Sampling Feeds

for Analyses" (PDF version, 655KB) states that a "lot" of hay should be harvested

from the same field consisting of similar types of plants, cutting dates, maturity,

variety, weed contamination, type of harvest equipment, curing methods, and storage

conditions.


Collect hay samples using a hay probe or core sampler that penetrates 12-18 inches

into the bale and has an internal diameter of at least 3/8 inch. Avoid overheating

the probe when using a drill, as heat can damage samples. Sample 15-20 bales from

each hay lot, then subsample if needed for analysis. For step-by-step instructions,

see the UNL NebGuide "Sampling Feeds for Analyses."


Once hay samples have been collected, store them in a sealed plastic bag in a cool,

dry place until they are ready to be submitted. Samples that contain over 15 percent

moisture should be frozen. Most commercial labs provide an information submittal

form that allows producers to select a standard feed test for forages.


Cattle feeds should be analyzed for moisture, protein, and energy. Producers may

also want to have forages tested for key minerals. When developing a ration for

cattle or comparing feeds, always use nutrient analyses on a dry-matter basis. After

formulating a ration on a dry-matter basis, the values can be converted to an as-is

basis using the feed's moisture content to determine the actual amount of feed to be

fed to the cattle.


Accurately testing hay takes time and money. However, the value of this information

is critical in accurately and cost-effectively formulating rations. Don't let the

small investment of time and money discourage you. It may be one of the best uses of

your time and money in your operation.


bottom of page